Author Topic: Husqvarna WR250 1988  (Read 2793 times)

0 Members and 1 Guest are viewing this topic.

Offline b490

  • Sr. Member
  • ****
  • Posts: 279
Re: Husqvarna WR250 1988
« Reply #30 on: February 24, 2016, 12:37:02 AM »
Ta Steve. They are smaller than the shocky eye if I recollect correctly.
Shocky ones have run out . :'(

 Hi Mike ,
     Horizontal linkage bearing  is  ;
  OD 30mm  ; ID  16mm   Housing width 15mm  ; Pivot ball width 19mm .
 
 The  bearing I used  has same O/D  &  I/D  (of course) but has a housing width 10mm & pivot ball width of 14mm .
 
 So a narrower bearing overall  but std  bolt mount collars are still used to keep bearing centred so does the job.

 Get them here ;
http://universalbearings.com.au/spherical-plain-bearing/spherical-plain-bearing-metric-25mm-30mm

 Item : GE 16 ES     description ; GE16DO 16X30X14/10

  Top & bottom shock mount bearings are smaller  spherical type
  O/D 20mm ; I/D 14mm  ; pivot ball width 15mm
 These were still OK , so were not replaced .
  HVA sell them  ;
    
 http://hva-factory.com/frame-fixings/husqvarna-ohlins-top-shock-spherical-bearing-evo-bikes-only-151133201
 or
     search local ;   http://universalbearings.com.au/contact-us

 Regards ,
                 Steve
  



Offline Mike52

  • Jr. Member
  • **
  • Posts: 78
Re: Husqvarna WR250 1988
« Reply #31 on: February 24, 2016, 10:19:26 AM »
Steve.

I've just realized that you're talking 88 and I'm talking 85 and 86 Duhh.

The lower shock bearing in the 86 is the only 30mm od one all the rest are smaller.
The Hva ones are top ones which are smaller .
Found the bearing you mentioned at SKF.


That HVA mob are not easy to deal with.
Ordered parts off them before , $100 min order , 3 mths wait , wrong parts , refuses to answer emails.
I will buy out of Mongolia before I go back there.
Mate had exactly the same result.
Cheers.
1985 WR/400 and 1986 WR/240 , PE 250c , DKW 125mx

Offline b490

  • Sr. Member
  • ****
  • Posts: 279
Re: Husqvarna WR250 1988
« Reply #32 on: March 09, 2016, 11:37:05 PM »
 Hey Mike ,
    I bought a lot of bits for my Husky/s  from Prime 8

 http://prime-8-racing.mybigcommerce.com/new-category-8/

 Give the local bloke a go before looking O/S   ; call   Mick 0459195580

  Regards ,
                   Steve